These stocks were designed to provide control while shooting and repeatability when gripping the weapon.  This is accomplished with a flat area at the front of the stock.  They are available in a variety of wood.  If you like we can furnish unfinished so you can apply your favorite finish.  These grips can be found as original equipment on many of S&W’s revolvers.

Cordia

Round Butt Finger Groove

Offering a fine compromise of control and concealment.  Available for round but K/L and N frame S&W revolvers.

Round Butt Smooth

This is the Round Butt Finger Groove grip without the finger grooves.  Available for round butt K/L and N frame S&W revolvers.

Square Butt Finger Groove

These grips are available for square butt guns.  We also make a conversion grip that converts a round butt frame to a square butt grip.  Recently S&W has been making the majority of their revolvers with round butts, these conversions allow a square butt grip to fit.  Available for round butt or square butt K/L and N frame S&W revolvers.

Square Butt Smooth

Once again this grip has all the features of the Square Butt Fingergroove but eliminates the finger grooves.  Available for round butt or square butt K/L and N frame S&W revolvers.

J Frame Round Butt Boot Grip

This grip is available with and without
finger grooves. They go to the bottom of the frame.

J Frame Combat and Banana Grips

These are our new grips for the J frame that extend past the bottom of the frame.Now there’s room for three fingers on the front to aid in control.